When returning your nanoCLEAR AR unit for service, always remember to follow the packing instructions correctly to prevent damage and unnecessary repairs.

Located in the back of the nanoCLEAR AR unit:

• Remove power cord
• Remove network data cable
• Remove data cable from wash module
• Remove video PC cable
• Remove high pressure supply hose
• Remove drain hose to wash module
• Remove all chemistry inlet tubing and replace with white caps
• Remove vacuum inlet
• Remove monitor from stand
• Remove monitor stand & push monitor plug down the tube that it is housed in

Located in side your nanoCLEAR AR system:

• Remove black mold stages
• Remove wash bowl ring
• Remove chemistry ring
• Remove chemistry bowl liner and discard
• Remove chemistry bowl and clean all chemistry from bowl
• Remove tips and filters and replace with red caps

Lock motion arm into position to prevent movement. If possible, place the motion arm in the chemistry bowl position and lower the arm. When the motion arm reaches the lowest point press STOP COATING BUTTON. Place bubble warp or packing material on either side of motion arm to prevent movement and install the shipping bracket provided.

Placing nanoCLEAR AR system in the special system box:

• Place tape or the shrink wrap it came with on the front door panel to prevent door from opening during shipping

• Gently place nanoCLEAR AR system into box making sure it rests inside the foam cut out inside of box
• Gently place the top foam insert on top of the nanoCLEAR AR system and push into place
• Close box and remove any labeling on the outside
• Tape box closed and place the appropriate shipping labels on the outside

When your system has been boxed up and/or you have any questions, please call Optical Dynamics Technical Support at 8000-587-2743.